Boat & 4WD Pack

• Captain’s Musket – 2-in-1 Wash & Flush Gun (garden hose connection)
• Salt Wash Detergent – 1L
• Outboard Engine Flush Solution – 1L
• 4WD Wash Detergent – 1L
• Microfibre Hand Mitt & Towel Kit
• Foam Brush Attachment – Connects to Musket for scrubbing while foaming
• Hard Bristle Brush – For wheels, trailers, and underbodies

This isn’t your average car wash kit. The Boat & 4WD Kit is built specifically for Aussie conditions—think salt spray, red dirt, beach drives, and muddy tracks. Whether you’re maintaining your outboard after a fish or cleaning red dust off your canopy, this kit gives you everything you need to do the job properly.

The Captain’s Musket lets you switch between foaming and engine flushing in seconds, cutting down your clean-up time. And with specially formulated washes for salt and 4WD grime, you’re treating your gear with the right products for the job.

Captain’s Musket
A powerful 2-in-1 gun that connects to any garden hose. Switch between foam mode for washing and flush mode for running solution through your engine.

Salt Wash Detergent (1L)
Breaks down salt, scum, and grime while leaving behind a protective barrier to help prevent corrosion. Perfect for boats, trailers, and coastal gear.

Outboard Engine Flush Solution (1L)
Flushes salt and debris out of your cooling system. Use with the Musket to protect your engine from internal rust and build-up.

4WD Wash Detergent (1L)
Made for Aussie off-road conditions. Lifts mud, red dirt, and road grime without damaging paint, wraps, or clear coat.

Microfibre Hand Mitt & Drying Towel
Soft on paint, tough on mess. The mitt helps break up grime while the towel leaves a streak-free finish.

Foam Brush Attachment
Screws onto the Musket so you can scrub while you foam. Ideal for hulls, panels, and any spots that need a little extra love.

Hard Bristle Brush
Built for tougher tasks like scrubbing tyres, wheels, underbodies and trailer frames.

1. Connect the Captain’s Musket

• Attach the Musket to your standard Aussie garden hose. No special fittings needed—just plug it in, fill the detergent chamber, and you’re ready to go.

2. Wash Your Boat or 4WD

• For boats: Fill the Musket with Salt Wash.. Switch to foam mode and cover the entire hull, deck, and trailer with foam. Let it dwell for 2–3 minutes, then scrub using the
• foam brush attachment for extra cleaning power.
  For 4WDs: Swap in the 4WD Wash. Foam down your vehicle, including underbody and wheel arches. Use the hard bristle brush for stubborn mud and build-up.
  
  

Rinse everything thoroughly with fresh water.

3. Flush Your Outboard or PWC Engine

• Empty the Musket and fill it with the Engine Flush Solution.
• Attach the hose to your engine’s flush port or earmuffs.
• Switch the Musket to flush mode and run the engine for 2–3 minutes to flush out salt, sand, and other debris.
  
  

4. Final Rinse & Dry

• After washing and flushing, give your vehicle or boat a final rinse to remove any leftover foam or residue.
• Use the microfibre drying towel to dry surfaces completely—this helps prevent water spots and gives you a clean, polished finish.

5. Pack It Up

• Rinse off your tools and store everything in your 15L bucket or wash station, ready to go for next time.

1. Connect the Captain’s Musket

• Attach the Musket to your standard Aussie garden hose. No special fittings needed—just plug it in, fill the detergent chamber, and you’re ready to go.

2. Wash Your Boat or 4WD

• For boats: Fill the Musket with Salt Wash.. Switch to foam mode and cover the entire hull, deck, and trailer with foam. Let it dwell for 2–3 minutes, then scrub using the
• foam brush attachment for extra cleaning power.
  For 4WDs: Swap in the 4WD Wash. Foam down your vehicle, including underbody and wheel arches. Use the hard bristle brush for stubborn mud and build-up.
  
  

Rinse everything thoroughly with fresh water.

3. Flush Your Outboard or PWC Engine

• Empty the Musket and fill it with the Engine Flush Solution.
• Attach the hose to your engine’s flush port or earmuffs.
• Switch the Musket to flush mode and run the engine for 2–3 minutes to flush out salt, sand, and other debris.
  
  

4. Final Rinse & Dry

• After washing and flushing, give your vehicle or boat a final rinse to remove any leftover foam or residue.
• Use the microfibre drying towel to dry surfaces completely—this helps prevent water spots and gives you a clean, polished finish.

5. Pack It Up

• Rinse off your tools and store everything in your 15L bucket or wash station, ready to go for next time.

Q: Will this work with any Aussie garden hose?
A: Yep! The Captain’s Musket connects straight onto a standard garden hose—no adapters needed.

Q: Can I use this on other vehicles?
A: 100%. It’s safe to use on cars, jet skis, trailers, bikes—basically anything that needs a proper clean after outdoor use.

Q: How often should I flush my engine?
A: After every saltwater session. Regular flushing helps prevent corrosion and extend the life of your outboard or PWC.

Q: Are the detergents safe on wraps and decals?
A: Yes—they’re pH-balanced and safe for all painted, vinyl-wrapped and plastic surfaces.

Q: Can I store it all in a bucket?
A: Absolutely. If you’ve got a 15L bucket, you can throw all the gear in for easy storage and transport.